What To Do If - Progress PBP5360 User Manual

7. Carefully lift (step 1) and remove (step 2)
the panels of glass one by one. Start
from the top panel of glass.
1
Clean the glass panels with water and
soap. Dry the glass panels carefully.
Installing the door and the glass panels
When the cleaning is completed, install the
glass panels and the oven door. Do the
above steps in the opposite sequence.
The middle panel has a decorative frame.
When you install this panel, make sure that
the screen-printing zone looks to the inner
side of the door. Make sure that after the
installation the surface of the glass panel
frame on the screen-printing zones is not
rough when you touch it.
Make sure that you install the middle panel
of glass in the seats correctly (refer to the il-
lustration).

WHAT TO DO IF...

Warning! Refer to "Safety information"
chapter.
Problem
The appliance does not
heat up.
The oven lamp does not
operate.
2
Possible cause
The appliance is deactivated.
The clock is not set.
The necessary settings are not set.
The automatic switch-off is on.
The Child lock is on.
The fuse in the fuse box is re-
leased.
The oven lamp is defective.
Make sure that you install the top panel of
glass in the seats correctly (refer to the illus-
tration).
Activate the appliance.
Set the clock.
Do a check of the settings.
Refer to "Automatic switch-off".
Refer to "Deactivating the Child
Lock".
Do a check of the fuse.
If the fuse is released more than
one time, contact a qualified elec-
trician.
Replace the oven lamp.
progress 37
Remedy