Pliance - Progress PBD3500X User Manual

Oven function
Turbo Grilling
True Fan Cooking
Pizza Setting
True Fan + Steam
Steam Cooking
1. Set the function
2. Press the cover of the water drawer to
open it. Fill the water drawer with water
until the Tank Full indicator comes on.
The maximum capacity of the tank is
900 ml. It is sufficient for approximately
55 - 60 minutes of cooking.
Important! Use only water as the liquid. Do
not use filtered (demineralised) or distilled
water. Do not use other liquids.
Do not put flammable or alcoholic liquids
(grappa, whisky, cognac, etc.) into the wa-
ter drawer.
3. Push the water drawer into its initial po-
sition.
4. Prepare the food in the correct cook-
ware.
5. Set the temperature between 130 °C
and 230 °C. Steam cooking does not
give good results in temperatures
above 230 °C.
6. Empty the water tank after the steam
cooking is completed.
Warning! Wait a minimum of 60
minutes after each use of the True Fan
+ Steam function in order to prevent
hot water from exiting the water outlet
valve.
Tank Empty indicator
The indicator shows that the tank is empty
and must be refilled.
For more information refer to "Steam Cook-
ing".
Tank Full indicator
The indicator shows that the oven is pre-
pared for steam cooking.
To cook large pieces of meat. The grill element and the oven fan oper-
ate one after the other and circulate hot air around the food.
To roast or roast and bake food with the same cooking temperature,
on more than one shelf, without flavour transference.
To make pizza, quiche or pie. The grill and bottom element provide di-
rect heat and the fan circulates the hot air to cook the pizza toppings
.
Application
or pie filling.
To steam dishes.
If you put too much water into the
tank, the safety outlet moves the
excess water to the bottom of the
oven.
Remove the water with a sponge or
cloth.
Emptying the water tank
Important! Make sure that the appliance is
cool before you start to empty the water
tank.
1. Prepare the draining pipe (C), included
in the same package with the user
manual. Put the connector (B) onto one
of the ends of the draining pipe.
2. Put the second end of the draining pipe
(C) into a container. Put it at a lower
position than the outlet valve (A).
3. Open the oven door and put the con-
nector (B) into the outlet valve (A).
4. Push the connector again and again
when you empty the water tank.
5. Remove the connector from the valve
when the water stops flowing.
progress 7
A
B
C