Configuring Ip Address Using Cli; Bsap 1920/1925 Led Description - ADTRAN BLUESOCKET 1920 Quick Start Manual

C
ONFIGURING THE
By default, DHCP is enabled on the BSAP 1920/1925. If you need to statically configure the IP address
for the BSAP, or statically configure AP discovery, follow these steps:
1. Ensure that the BSAP is connected to the network or a computer and powered as indicated in
Connecting to the BSAP
BSAP from the DHCP server (based on the MAC address of the BSAP).
2. If the BSAP is connected to a computer, specify that the computer's TCP/IP setting is On or
Enabled by navigating to Control Panel > Network Connections and double-clicking the
connection of your network interface card. Select Internet Protocol (TCP/IP) and select
Properties. Then specify that the TCP/IP setting is enabled. If the BSAP is connected to the
network, connect your computer to the same network.
3. If the BSAP is connected to a computer, set your PC to a static IP address of 192.168.190.2 with a
subnet mask of 255.255.255.0. If the BSAP is connected to the network, configure your PC to a
static IP address in the same network (or obtain an IP address using DHCP).
4. Next, access the BSAP's command line interface (CLI) using an SSH client. Open an SSH
connection using the unit's default IP address (192.168.190.1), or the IP address obtained from the
DHCP server (if connected to the network), and port 2335. To access the unit using vWLAN, and for
more instructions about CLI configuration, refer to the
available online at https://supportforums.adtran.com.
C
ONFIGURING THE
More detailed documentation for configuring the BSAP 1920/1925 is provided in the
Administrator's Guide, available online at https://supportforums.adtran.com.
BSAP 1920/1925 LED D
BSAP State
Boot Loader Initialization
Operating System
Initialization
LAN Initialization
Discovering vWLAN
Firmware Upgrade
(download)
Firmware Upgrade
(writing or verifying)
Firmware Upgrade
Complete
Operational with No
Activity on Radios
Operational with Activity
on Radios
4
BSAP' IP A
S DDRESS
. If the BSAP is connected to the network, obtain the IP address of the
A
PPLICATION
ESCRIPTION
Status
Off
Solid Green
Flashing Green
Flashing Green
Flashing Orange (Slow)
Flashing Orange (Fast)
Solid Orange
Solid Green
Solid Green
Copyright © 2013 ADTRAN, Inc. All Rights Reserved.
U CLI
SING THE
Bluesocket vWLAN Administrator's
Ethernet
Off
Off
Flashing Orange
Flashing Green
Flashing Green
Flashing Green
Flashing Green
Flashing Green
Flashing Green
Guide,
vWLAN
Radio
Solid Orange
Off
Off
Off
N/A
N/A
N/A
Solid Green
Flashing Green