Intel Express 10 User Manual page 64

C H A P T E R 3 Console Command Reference
get-stp
get-stp
Displays the current state of spanning tree (either enabled or
disabled). By default, spanning tree is enabled in accordance with
802.1d.
SYS_console> get-stp
Running Spanning Tree engine is enabled
Next session the Spanning Tree engine will be enabled
set-stp
set-stp {enable|disable}
Enables or disables the spanning tree protocol. Enabled is the default.
Enabling or disabling spanning tree doesn't take effect until the
SNMP agent is reset (
off and then on again).
get-st-bcfg
get-st-bcfg
Displays the spanning tree bridge parameters. If spanning tree is
disabled, parameters aren't displayed.
SYS_console> get-st-bcfg
802.1D SPANNING TREE BRIDGE INFO
==================================
Designated Root
Bridge Priority
Root Cost
Root Port
Max Age
Hello Time
Hold Time
Forward Delay
Bridge Max Age
Bridge Hello Time
Bridge Forward Delay :
,
warm-reset cold-reset
: 8000-0020-1a00-0a5b
: 32768
: 0
: 0
: 20
: 2
: 1
: 15
: 20
: 2
15
, or turning the power
61