Intel Express 10 User Manual page 45

C H A P T E R
42
3 Intel Express 10/100 Fast Ethernet Switch
set-rsw-file
set-rsw-file <filename>
Sets the name of the SNMP agent software remote file for download.
This is the file downloaded from a TFTP server, if you've defined
one.
get-tftp-srvr
Displays the TFTP server IP address to be used for downloading
SNMP agent software.
set-tftp-srvr
set-tftp-srvr <IPaddress>
Sets the TFTP server IP address to be used for downloading SNMP
agent software.
sw-dnld
Starts the SNMP software download from the defined TFTP server.
get-par-file
Displays the name of the SNMP agent parameter file.
set-par-file
set-par-file <filename>
Sets the name of the SNMP agent parameter file to be downloaded by
BOOTP. The filename must match the name of the parameter file on
the BOOTP server. The format for the parameter file is:
<switch_hardware_address> : <read_comm> : <write_comm>
Example:
00-A0-C9-00-01-23 : public : private
You can find the
switch_hardware_address
command (it's the system MAC address).
set-fg-param
set-fg-param <dest> <source> <fill_byte> <length>
Sets the frame generator parameters. The
separated MAC addresses. The
the entire packet except for the first 12 bytes. The
length of the packet excluding CRC.
by using the
and
dest source
is a single byte used to fill
fill_byte
length
sys-stat
are dash-
is the total