Intel Express 10 User Manual page 44

C H A P T E R 3 Console Command Reference
init-nvram
Resets the NVRAM on the SNMP agent to the default values. The
changes don't take effect until you use the
commands or cycle the power. Appendix A lists the default values.
set-line-slip
set-line-slip {9600|19200|38400}
Changes the console serial port to SLIP mode for out-of-band SNMP
management. The command argument is the new baud for the
interface. You can use SLIP with a terminal server but not with a
modem. Configure the SLIP interface using the
console command. Return the serial port to console mode by pressing
E three consecutive times from a terminal.
SYS_console> set-line-slip 9600
RS232 baudrate in SLIP mode changed to 9600 bps
To switch back to Administrative Interface Mode press <CR> three
times. Note that the Administrative Interface Mode baudrate will
be 9600
get-sw-file
Displays the name of the SNMP agent software file. The file is stored
internally in the switch.
set-sw-file
set-sw-file <filename>
Sets the name of the file to be downloaded by TFTP (trivial file
transfer protocol). Use this command to update the switch's firmware.
The filename must match the name of the agent software file on a
TFTP server. When you use TFTP, increase the per-packet
retransmission time-out value on the TFTP server (not the switch) to
10 seconds, because the SNMP agent must first erase its flash
EEPROM, which takes about 30 seconds.
get-rsw-file
Displays the name of the SNMP agent software remote file. If you
don't define one with the
internal file.
warm-reset
set-slip-conf
command, the switch uses its
set-rsw-file
or
cold-reset
41