Table of Contents
Advertisement
Understanding the printer menus
Use
Alarms
Alarm Control
Cartridge Alarm
Timeouts
Sleep Mode
Disabled
1–120
Timeouts
Print with Display Off
Allow printing with display off
Display on when printing
Timeouts
Hibernate Timeout
Disabled
20 minutes
1–3 hours
6 hours
1–3 days
1–2 weeks
1 month
Timeouts
Hibernate Timeout on Connection
Hibernate
Do Not Hibernate
Timeouts
Screen Timeout
15–300
To
Set an alarm to sound when operator intervention is required.
For each alarm type, select from the following options:
Off
Single
Continuous
Notes:
•
Single is the factory default setting for Alarm Control. This
sounds several short beeps.
•
Off is the factory default setting for Cartridge Alarm.
•
Continuous repeats several short beeps at a regular interval.
Set the amount of time the printer waits after a job is printed before
it goes into a reduced power state.
Notes:
•
20 minutes is the factory default setting.
•
Disabled appears only when Energy Conserve is set to Off.
•
Lower settings conserve more energy, but may require
longer warm‑up times.
•
Select a high setting if the printer is in constant use. Under
most circumstances, this keeps the printer ready to print.
Print a job while the display is off.
Note: Display on when printing is the factory default setting.
Set the amount of time the printer waits before it enters Hibernate
mode.
Note: 3 days is the factory default setting.
Set the printer to hibernate mode when there is an active Ethernet
connection.
Note: Hibernate is the factory default setting.
Set the amount of time before the display returns to a Ready state.
Note: 30 seconds is the factory default setting.
113
Advertisement
Table of Contents
