Output; [:State] - HP E1366A User Manual

OUTPut

Subsystem Syntax

[:STATe]

Parameters
Comments
Example
[:STATe]?
Example
Chapter 5
The subsystem enables or disables the " Trig Out" port of the
OUTPut
HP E1300A/E1301A mainframe or the HP E1405A/E1406A module.
OUTPut
[:STATe] ON | OFF | 1 | 0
[:STATe]?
OUTPut[:STATe] ON | OFF | 1 | 0
the rear panel of the HP E1300A/E1301A mainframe or the
HP E1405A/E1406A module.
and
OUTPut[:STATe] OFF | 0
Parameter Name
ON | OFF | 1 | 0
Enabling "Trig Out" Port: When enabled, a pulse is output from
the " Trig Out" port after each scanned switchbox channel is closed.
If disabled, a pulse is not output from the port after channel closures.
The output pulse is a +5 V negative-going pulse.
"Trig Out" Port Shared by Switchboxes: When enabled, the
" Trig Out" port is pulsed by any switchbox each time a scanned
channel is closed. To disable the output for a specific switchbox,
send the
OUTPut[:STATe] OFF
that switchbox.
Related Commands:
*RST Condition:
Enable "Trig Out" Port
OUTP:STAT ON
queries the present state of the " Trig Out" port. The
OUTPut[:STATe]?
command returns 1 if the port is enabled or 0 if the port is disabled.
Query "Trig Out" Port Enable State
This example enables the " Trig Out" Port and queries the enable state. The
OUTPut[:STATe]? command returns 1 since the port is enabled.
OUTP:STAT ON
OUTP:STAT?
HP E1366A/E1367A RF Multiplexers Command Reference
enables/disables the " Trig Out" port on
OUTPut[:STATe] ON | 1
disables the port.
Parameter Type
boolean
or
OUTPut[:STATe] 0
[ROUTE:]SCAN , TRIGger:SOURce
OUTPut[:STATe] OFF (port disabled)
!
Enable "Trig Out" port to output
pulse after each scanned channel is
closed
! Enable "Trig Out" port
! Query port enable state
enables the port
Range of Values
ON | OFF | 1 | 0
command for
47