Command Quick Reference - HP E1366A User Manual

Command Quick Reference

Command
ABORt
ARM number
:COUNt <
:COUNt? [MIN |MAX]
DISPlay :MONitor[:STATe] <
:MONitor:CARD <
INITiate :CONTinuous ON |OFF
:CONTinuous?
[:IMMediate]
OUTPut [:STATe] ON |OFF
[:STATe]?
[ROUTe:] channel_list
CLOSe <
CLOSe? < channel_list
OPEN < channel_list
channel_list
OPEN? <
SCAN < channel_list
SCAN:MODE NONE |VOLT |
RES |FRES
STATus :OPERation[:EVENt]?
:OPERation:ENABle
SYSTem :ERRor?
:CDEScription? <
number
:CTYPe? <
number
:CPON <
TRIGger [:IMMediate]
:SOURce BUS
:SOURce EXTernal
:SOURce HOLD
:SOURce IMMediate
:SOURce?
Command Title
*RST Reset
*TRG Bus Trigger
*TST? Self-Test
60 HP E1366A/E1367A RF Multiplexers Command Reference
The following tables summarize SCPI and IEEE 488.2 Common (*)
commands for the RF Multiplexer modules used in a switchbox.
SCPI Commands Quick Reference
Description
Abort a scan in progress.
Multiple scans per INIT command.
>
Query number of scans.
boolean > Selects monitor mode.
number >|AUTO Selects module to be monitored.
Enables/disables continuous scanning.
Query continuous scan state.
Starts a scanning cycle.
Enables/disables "Trig Out" pulse.
Query port enable state.
Close channel(s).
>
Query channel(s) closed.
>
> Open channel(s).
Query channel(s) opened.
>
Define channels for scanning.
>
Sets scan mode.
Returns status of Operation Status register.
Enables the Operation Status register to set a bit in the Status register.
Returns error number/message in a switchbox Error Queue.
number Returns description of module in a switchbox
>.
> Returns the module type.
Sets specified module to its power-on state.
>|ALL
Causes a trigger to occur.
Trigger source is *TRG.
Trigger source is "Event In".
Hold off triggering.
Continuous (internal) triggers.
Query scan trigger source.
IEEE 488.2 Common Commands Quick Reference
Description
Opens all channels, and invalidates current channel list for scanning. Sets
ARM:COUN 1, TRIG:SOUR IMM, and INIT:CONT OFF.
When scan is enabled and trigger source is TRIG:SOUR BUS, use the
*TRG command to trigger the switchbox to advance the scan.
Always returns 0.
Chapter 5