Ieee 488.2 Common Commands - HP E1366A User Manual

IEEE 488.2 Common Commands

Command Title
*IDN? Identification
*RST Reset
*TST? Self-Test
*OPC Operation Complete
*OPC? Operation Complete Query
*WAI Wait to Complete
*CLS Clear status
*ESE Event status enable
*ESE? Event status enable query
*ESR? Event status register query
*SRE Service request enable
*SRE? Service request enable query
*STB? Read status byte query
*TRG Trigger
*RCL Recall instrument state
*SAV Store instrument state
Note: These commands apply to many instruments and are not documented in detail here. See the
appropriate HP B-size or C-size configuration guide, or the
Chapter 5
The following table lists the IEEE 488.2 Common (*) Commands that apply
to the RF Multiplexer module. The operation of some of these commands is
described in Chapter 4 of this manual. For information on Common
Commands, refer to the HP B-size configuration guide or the ANSI/IEEE
Standard 488.2-1987.
Description
Returns identification string of the switchbox.
Opens all channels, and invalidates current channel list for Opens all
channels, and invalidates current channel list for scanning. Sets
ARM:COUN 1, TRIG:SOUR IMM, and INIT:CONT OFF.
Always returns 0.
See note below.
See note below.
See note below.
Clears all status registers (see STATus:OPERation[:EVENt]?).
See note below.
See note below.
See note below.
Enables status register bits (see Chapter 4 for operation).
See note below.
See note below.
Triggers the switchbox to advance the scan when scan is enabled and
trigger source is TRIGger:SOURce BUS.
See note below.
See note below.
ANSI/IEEE Standard 488.2-1987
HP E1366A/E1367A RF Multiplexers Command Reference
for more information.
59