Trigger; [:Immediate] - HP E1366A User Manual

TRIGger

Subsystem Syntax

[:IMMediate]

Comments
Example
56 HP E1366A/E1367A RF Multiplexers Command Reference
The subsystem controls the triggering operation of RF multiplexer
TRIGger
modules in a switchbox.
TRIGger
[:IMMediate]
:SOURce BUS | EXTernal | HOLD | IMMediate
:SOURce?
TRIGger[:IMMediate] causes a trigger to occur when the defined trigger
source is TRIGger:SOURce HOLD
Executing the
TRIGger[:IMMediate]
must be defined with
INITiate[:IMMediate]
TRIGger[:IMMediate]
or Source Remains: The
HOLD BUS
TRIGger:SOURce BUS
triggering a switchbox with the
Related Commands:
Advancing Scan Using the
This example uses the TRIGger
single-module switchbox from channel 00 through 03. Since
TRIGger:SOURce HOLD
is executed.
TRIGger
TRIG:SOUR HOLD
SCAN (@100:103)
INIT
loop statement
TRIG
increment loop
or TRIGger:SOURce BUS
Command: A channel list
channel_list
[ROUTe:]SCAN <
command must be executed before
will be executed.
TRIGger:SOURce HOLD
commands remain in effect, if selected, after
TRIGger[:IMMediate]
,
INITiate [ROUTe:]SCA
Command
TRIGger
command to advance the scan of a
is set, the scan is advanced one channel each time
! Sets trigger source to HOLD
! Defines channel list
! Begin scan, close channel 00
! Start count loop
! Advance scan to next channel
! Increment loop count
.
and an
>
or
command.
N
Chapter 5