Output; [:State] - HP E1343A User Manual

Subsystem Syntax

[:STATe]

Parameters
Comments
Example
[:STATe]?
Example
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The subsystem enables or disables the "Trig Out" port of the

OUTPut

HP E1300/E1301 Mainframe.
OUTPut
[:STATe] < state >
[:STATe]?
state >
OUTPut[:STATe] <
the HP E1300A/E1301A Mainframe.
OUTPut[:STATe] OFF|0
Parameter Name
< state >
•
Enabling "Trig Out" Port: When enabled, the "Trig Out" is pulsed each time
a channel is closed during scanning. When disabled, the "Trig Out" is not
pulsed.
•
Output Pulse: The pulse is a + 5 V negative-going pulse.
•
"Trig Out" Port Shared by Switchboxes: When enabled, the "Trig Out" may
be pulsed by any switchbox each time a channel is closed in a switchbox
during scanning. To disable the output for a specific switchbox, send the
OUTPut[:STATe] OFF
•
Related Commands:
•
*RST Condition: OUTPut[:STATe] OFF
Enabling "Trig Out" Port
OUTP ON
OUTPut[:STATe]? queries the present state of the "Trig Out" port. The command
returns 1 if the port is enabled, or
Query "Trig Out" Port State
OUTP ON
OUTP:STAT?
enables/disables the "Trig Out" port on the rear panel of
OUTPut[:STATe] ON|1
disables the port.
Parameter Type
boolean
or OUTPut[:STATe] 0 command for that switchbox.
,
[ROUTE:]SCAN TRIGger:SOURce
(port disabled)
Enables "Trig Out" port for pulse output.
0 if disabled.
Enables "Trig Out" port for pulse output.
Query port enable state.
Relay Multiplexer Command Reference
OUTPut
enables the port and
Range of Values
0 |1|ON|OFF
57