Interpreting Scsi Bus Status Indicator Leds; Viewing Current Scsi Address Settings; Table 3-3 Scsi Status Indicators - HP SureStore 4115w User Manual

Table 3-3
Operating the Library
Setting and Viewing SCSI IDs

Interpreting SCSI Bus Status Indicator LEDs

Each SCSI bus has an LED to indicate the bus status.
SCSI Status Indicators
Indication
Steady green Port active and OK. Internal (on-board) termination
enabled.
Flashing green Port active and OK. Internal (on-board) termination
disabled.
No light Port not active or not configured.
Flashing red Bus mismatch or loss of external termination power.
Flashing yellow Bus off-line for on-line drive replacement.

Viewing Current SCSI Address Settings

1 2 ADMIN *
To view the current SCSI address settings:
1. Verify that the drive status displays. If not, press
2. Press until ADMIN * displays, then press
NEXT
3. Enter the three-part numerical password (see "Entering the Administration
Menu Password" on page 3-9).
4. Press until SCSI IDs * displays, then press
NEXT
5. SET IDS * displays. Press
6. BUS # LIB ID # or BUS # DRV # ID * displays. (BUS # LIB ID # stands for
the current SCSI ID of the robotics controller. BUS # DRV # ID # is the current
SCSI ID setting for the displayed drive number and its associated BUS#.)
7. Press or
NEXT PREV
8. Press until the next operation to perform displays, or until the drive
CANCEL
status (library "ready" state) displays.
3-14
SCSI IDs * VIEW IDs *
until VIEW IDS * displays, then press
NEXT
to scroll through the current address settings.
Status
until it does.
CANCEL
.
ENTER
.
ENTER
.
ENTER