Table of Contents
Advertisement
NOTE
NOTE
Installing the Tape Library
Installation Overview
Installation Overview
Before you install the tape library:
•
Make sure you have the components listed in Table 1-2 on page 1-4.
•
Become familiar with the back of the tape library, as shown in "Tape Library
Rear Panel" on page 1-4.
To install the library, you must:
1. Choose a location.
2. Unpack the library.
3. Install the SCSI host adapter card.
4. Mount the library in a rack (rackmount configuration only).
5. Set the SCSI interface mode switch.
6. Connect the tape library.
7. Power on the system.
These steps are explained in this chapter. This chapter also explains how to move or
ship the library.
After the library is installed, you must perform additional tasks explained in
Chapters 2 and 3.
1-2
Advertisement
Table of Contents
