HP SureStore 4115w User Manual page 78

NOTE
Operating the Library
Cleaning the Library Tape Drives
selected is flashing.) If the storage slot location is correct, press
select a different storage slot location, press
slot location displays, the press
6. ###### SLOT # displays ("######" is a barcode number or is blank if
barcodes are not being used, and the storage slot location number is flashing).
Press to select the displayed storage slot location or press
ENTER
to select a different storage slot location, then press
7. CLEAN DRIVE 1 displays and the "1" is flashing. Press
number to clean displays, then press
To clean both drives, press
then press .
ENTER
If the drives are not empty, a DRIVE FULL message displays, and the drives must
be emptied before they can be cleaned.
If the slot location chosen in Step 4 did not contain a cleaning cartridge, NOT
CLEAN CART displays briefly, then CLEAN FAIL # displays. Press
twice to return to the "ready" state. Check the bulk load magazines in the library to
locate the cleaning cartridge. If no cleaning cartridge is present, insert one into an
available slot.
In the event of a drive error, such as a serial communications failure, FAILED
displays and the CLEAN DRIVES * menu displays.
CLEANING DRV # displays (# is the number of the drive being cleaned). When
the drive has been cleaned, CLEANED DRV # displays briefly, then CLEAN
DRIVES * is again displayed.
8. Press until the next operation to perform displays, or until the drive
CANCEL
status indicators (library "ready" state) are displayed.
3-24
NEXT
.
ENTER
.
ENTER
or until CLEAN DRIVE ALL displays,
NEXT PREV
. To
ENTER
until the correct storage
or
NEXT PREV
.
ENTER
until the drive
NEXT
to
CANCEL