HP SureStore 4115w User Manual page 91

5. Press or until DRIVE STATUS displays, then press
NEXT PREV
ON GOOD displays.
• If the damaged tape is in drive 1, press
• If the damaged tape is in drive 2, press
then press .
ENTER
DRV # ON GOOD displays, where "#" is the drive number and ON GOOD is
flashing.
6. Press until DRV # OFF FAILED displays then press
NEXT
7. CHANGE CONFIRMED displays briefly, then ONLINE REPAIR * displays.
Press .
ENTER
8. DRIVE POWER * displays.
9. Press or until DRIVE STATUS displays, then press
NEXT PREV
10. Press or until DRV # OFF FAILED displays (where "#" is the
NEXT PREV
number of the drive that was just taken off-line) then press
11. DRV # OFF FAILED displays, where "#" is the drive number and OFF
FAILED is flashing.
12. Press until DRV # ON GOOD displays, then press
NEXT
13. SETTING UP DRIVE displays briefly while the drive communication tests run,
following by CHANGE CONFIRMED and then ONLINE REPAIR *.
14. Press twice to return to the drive numbers and status indicators ("ready"
CANCEL
state).
15. Try reading the damaged tape again.
• If the tape can be read, back up data from the damaged cartridge to another
tape cartridge and discard the damaged one.
• If the tape cannot be read, call your service representative.
Operating the Library
Using Online Drive Replacement
ENTER
.
ENTER
until DRV 2 ON GOOD displays,
NEXT
.
ENTER
ENTER
.
ENTER
.
ENTER
. DRV 1
.
3-37