HP SureStore 4115w User Manual page 80

Table 3-4
Config Name
RECOVERY
ON/OFF
RESTORE
DEFAULTS
CLEAR
ODOMETERS
STARWARS
ON/OFF
NEW PASSWORD
SCSI LOG
ON/OFF
SECURE ON/OFF
POWER SECURE
ON/OFF
Operating the Library
Setting Configuration Options
Configuration Options
If the configuration is set to ON, the library attempts to recover
from errors. If the configuration is set to OFF, the library
immediately stops moving if an error occurs. The default
configuration is RECOVERY ON and should remain ON under
normal conditions.
Sets all library configurations back to their default settings.
Used by service personnel only. Sets all library odometers back to
zero.
Used by service personnel only and should be set to ON during
normal operation. If the configuration is set to ON, the library
runs with the vertical sensors enables. If the configuration is set to
OFF, the library runs with vertical sensors disabled.
Allows you to change the numerical password required to access
the options under the ADMIN * menu on the library control panel.
These options include configurations, tests, and information logs.
To change the password, see "Setting a New Administration Menu
Password" on page 3-10.
Used by service personnel only, and should be set to OFF
during normal operation. Tracks internal SCSI states and saves
the information to a log.
When set to ON, tape magazines cannot be loaded or removed. If
the configuration is set to OFF, the library operates in its default
state, which allows cartridges to be loaded and removed.
When set to ON, the SECURE ON/OFF configuration setting is
retained in the event of a power outage. If this configuration is set
to OFF, the library returns to its default setting of POWER SECURE
OFF when power is returned after being shut off.
3-26
Description Default
ON
—
—
ON
—
OFF
OFF
OFF