Entering the Administration Menu Password
1 2
ADMIN *
A numeric password is required to access options beneath ADMIN* menu of the
library (see Figure 3-2 on page 3-8). A three-part default password of 000-000-000
is set at the factory. To change the password, see "Setting a New Administration
Menu Password" on page 3-10.
To enter the password:
1. Verify that the drive status displays. If it does not display, press
does.
2. Press
until ADMIN * displays, then press
NEXT
3. PSWD 000-000-000 displays, and the first set of zeros flashes.
Press
to accept this number (if no password has been set), or press
ENTER
or
until the correct number displays. Press
PREV
4. The middle set of zeros flashes.
Press
to accept this number (if no password has been set), or press
ENTER
or
until the correct number displays. Press
PREV
5. The last set of zeros flashes.
6. Press
to accept this number (if no password has been set), or press
ENTER
or
until the correct number displays.
PREV
7. Press
. INFO * displays.
ENTER
To access options under the ADMIN * menu, press
option displays, then press
Entering the Administration Menu Password
CONFIG *
ENTER
PREV
.
ENTER
Operating the Library
until it
CANCEL
.
NEXT
.
ENTER
NEXT
.
ENTER
NEXT
or
until the desired
NEXT
3-9