Table of Contents
Advertisement
If Information Units is enabled (parallel SCSI only), the drive will drop the bus on detecting a CRC
error during a LQ_IU. If the CRC error occurs during the Information Units command phase or
data out phase, the drive will return
4703h (Information Unit CRC error detected).
On detecting an Initiator Detected error, the drive will return
sense of 4800h (initator detected error message received). The exception is when Information
Units mode is enabled (parallel SCSI only), when one of the following occurs:
If an IDE message is received during a LQ_IU, the drive drops the bus and retries the LQ_IU
•
pair.
•
If the message is received during Status IU, the drive retries the LQ_Status pair.
If the message is received during Data IU, the drive sends a LQ_Status with
•
CONDITION
Disconnect strategy
The disconnect strategy used by the drive is based on maximizing the use of the bus for large
sequential data transfers from a large data buffer. The drive will disconnect whenever it believes
that it will provide better bus use. This may be between command and data phases, between
bursts of data or before sending status. However, the drive will guarantee that it sends the
configured maximum burst size or the remaining data in the transfer in any single data phase
burst if the maximum burst size has been set to a value other than zero.
The following diagram gives an overview of the drive's disconnect strategy:
16
Interface Implementation
CHECK CONDITION
and additional sense of 4800h.
with a CRC error. Additional sense is set to
CHECK CONDITION
with additional
CHECK
Advertisement
Table of Contents
