Messages; Message Out Support - HP Q153090901 Technical Reference Manual

Ultrium tape drives generation 3 drives volume 3-the scsi interface
Table of Contents

Advertisement

2 Messages

This chapter includes all SCSI messages, both supported and unsupported. Parts of this chapter
come from Section 5, Logical Characteristics, of the SCSI standards (see page 11).
The message system provides an initiator and a target on the SCSI bus with a means of managing
communication. The available messages are listed in this chapter.

Message Out support

Name
Abort
Bus Device Reset
Extended Message
Identify
Initiator Detected
Error
Message Parity Error
Message Reject
No Operation
Code Support
An abort condition is generated (see "Abort handling" on page 14).
06h
0Ch
A reset condition is generated (see "Reset strategy" on page 13).
01h
See "Extended Message Support" below.
The Identify Out message is sent by the initiator to identify the Logical
80h+
Unit to be accessed and to set Disconnect Privilege.
The initiator has detected an error in the data being sent in a Command,
05h
Data or Status phase. The drive will send a restore data pointers
message to retry the data transfer. (See
details).
If the message is received immediately after an Identify message or after
the Command Complete message has been sent, the drive will go Bus
Free.
The initiator has detected a parity error in a message. The drive will retry
09h
the message. (See
"Message In
If the message is received immediately after an Identify message or after
the Command Complete message has been sent, the drive will go Bus
Free.
07h
This message is sent when the initiator does not support a message sent
by the drive or that the message is inappropriate. If the message being
rejected is Disconnect, Synchronous Data Transfer Request or Wide Data
Transfer Request, the operation continues without those features. For all
other messages, the message is treated as an Abort message.
If the message is received during a Command, Data or Status phase,
immediately after an Identify message or after the Command Complete
message has been sent, the drive will go Bus Free.
08h
This message has no effect and is ignored.
"Message In
support" below for
support" below for details).
23

Advertisement

Table of Contents
loading

Table of Contents