ETX Powered Loudspeakers
Installing the eyebolts
To install the eyebolts, do the following:
1.
2.
Notice!
If the eyebolts are removed reinstall the screws.
If the screws are not reinstalled air leaks occur in the enclosure, resulting in undesirable
performance.
Warning!
Eyebolts must be fully seated and oriented in the plane of pull. Always use fender washers at
!
least 1.5 inch in diameter and 1/16 inch thick under the eyebolt to distribute the load on the
enclosure.
Figure 4.8: Eyebolt shown with and without washer
2014.02 | 03 | F.01U.276.083
Remove the M10 screws from the suspension points.
Replace the M10 screw with the fender washer and eyebolt.
Washer
Used
No
Washer
Used
User Manual
Electro-Voice