Fujitsu 5000 Series User Manual page 52

6
Secure the internal option with two screws.
7
Connect the flat cable.
Connect the flat cable appropriate for the internal
option to be installed.
- To install an IDE-standard internal option,
connect the flat cable to the master or slave
connector according to the setting of the
internal option.
If a magneto-optic disk has been installed by
a custom-made specification, connect the
magneto-optic disk drive to the master
connector and the other internal option to the
slave connector. However, to install a hard
disk, connect the hard disk to the master
connector and connect the magneto-optic disk
drive to the slave connector.
Connected when set to the master
- To install a SCSI interface internal option:
Connect the flat cable to the SCSI card in the
expansion slot.
42
Connected when set to the slave
MASTER SLAVE
Connected to the riser board
Pin 1
Blue or red line