Replacing A Internal Hard Disk Equipped As Standard - Fujitsu 5000 Series User Manual

Replacing a internal hard disk equipped as standard

This section explains how to replace a standard-equipped internal hard disk with a hard disk of
larger capacity.
1
Set up the jumper switch.
See the manual accompanying the internal hard
disk and make sure that the jumper switch has
been set to master, or cable select.
2
If retaining metal brackets are mounted on
both sides of the internal hard disk to be
replaced, remove them.
Remove the screws (4) to remove the retaining
metal brackets.
3
Remove the upper cover.
4
Disconnect the hard disk cables.
Disconnect the power cord and flat cables
connected to the hard disk.
5
Remove the retaining metal bracket.
Remove the screw (one), then remove the
retaining metal bracket by sliding it in the
direction of arrow
it in the direction of arrow
2
1
, then arrow , and then lift
3
.
3
1
2
35