Fujitsu 5000 Series User Manual page 46

6
Replace the internal hard disk.
Remove the four blue screws on the back of the
retaining metal bracket, and then remove the
standard-equipped hard disk. Then, use the blue
screws to install the new hard disk.
7
Install the internal hard disk in the PC main
unit.
Install the retaining metal bracket in the original
position by lowering it in the direction of arrow
1
, sliding it in the direction of arrow
sliding it again in the direction of arrow
secure the retaining metal bracket with the screw
that was removed in step 5.
8
Connect the cables to the hard disk.
Reconnect the power cord and flat cables that
were disconnected in step 4.
Be sure to connect the flat cables to the
connector with the MASTER marking.
To prevent malfunction, be sure to place the
cables back in their original positions.
9
Attach the upper cover.
10
Use BIOS setup to set the hard disk.
Set the type of the installed hard disk by BIOS
setup ( see "Primary master/slave" in "Main
Menu," "BIOS Setup").
Point
BIOS Setup
A guide to your Deskpower 5000 BIOS is available online. Please visit our technical support section
at www.fujitsu-pc-asia.com. Once there, click on the desktop series from the pull down menu and
select the appropriate desktop model.
36
2
, and then
3
. Then,
1
3
2