Lennox icomfort Setup Manual page 11

If you select reset and then confirm, the highlighted device will be reset
to its factory setting. You would see a screen similar to figure 14, but ref-
erencing only the selected device.
Resetting ALL devices to their factory default
settings will cause the system to restart the
setup process. If you want to continue, then
press 'confirm' or press 'cancel'.
confirm
Figure 14. Reset device confirmation note
cancel
Page 11
After a reset, the device which had its settings reset to
default will display in the system devices screen in red
type. You will be required to highlight the red−type de-
vice(s) and use edit (see figure 12) to change, or at
least view the changed settings of the red−type de-
vices .
In the edit mode, the feature list will show the selected
device's changed features in red type. Use the up/
down arrows to select each red−typed feature and
press edit. Make changes to the settings using the
Edit tools if desired, or at least, press save in each fea-
ture screen. Upon saving, the previous screen will
display and the type will again be black. Press back to
return the Modify communicating device settings
screen.
At this point press next step to advance to the test controls.
icomfortt Touch Screen 7−Day Programmable Thermostat
Installer setup − Page 6 of 8
HP
XP19−060−230−06
5809K00015
AIR HANDLER
CBX32MV−60
5809K00020
Equipment
Name
Electric Heating
Airflow
Low Cooling
Airflow
Low Cooling
Airflow