Self-Booting The Remote Access Concentrator - Nortel 5399 Hardware Installation Manual

Chapter 2 Installing the Model 5399 Remote Access Concentrator Module

Self-booting the Remote Access Concentrator

The Remote Access Concentrator comes equipped with Flash memory
that contains an operational image you can use to self-boot the module.
To self-boot your Remote Access Concentrator, perform the following
steps:
1. Initialize the IP address parameters using the manual
initialize method.
The manual initialization method is described in
Initializing the IP Address Parameters" on page
2. Enter the sequence command at the monitor prompt.
The following prompt is displayed:
Enter interface sequence [net]::
3. Enter self, net as the sequence.
The monitor prompt is displayed.
4. Enter the boot command at the monitor prompt.
The display looks similar to this:
monitor:: boot
Waiting for CMB Config Block Info...
Requesting default boot file "OPER_64_ENET.SYS" for
MOP/VMS\ loads and "oper.64.enet" for all other
protocols. Unanswered requests shown as '?',
transmission errors as '*'.
Booting file: "OPER_64_ENET.SYS" from SELF
Loading image from SELF ...
.................................................
Load Completed
The self-boot takes 10 seconds to complete. Once the Remote
Access Concentrator has booted, Monitor Mode is no longer
active.
Nortel Networks 5399 Access Switch Hardware Installation Guide
"Manually
2-26.
2-31