Table 2-1. Model 5399 Configuration Options - Nortel 5399 Hardware Installation Manual

Chapter 2 Installing the Model 5399 Remote Access Concentrator Module
Nortel Networks 5399 Access Switch Hardware Installation Guide
2-2
• An appropriate subnet mask
• A host with Model 5399 software installed (if not booting
from FLASH memory)
The Model 5399 can receive its operational image from any one of these
sources:
• A UNIX host running erpcd
• FLASH memory (self boot)
• Another Model 5399 configured as a boot host
• Any host supporting TFTP
• A Windows NT host running erpcd
The Remote Access Concentrator supports Windows NT
tools. Remote Annex Server Tools for Windows NT
you to boot and configure the Remote Access Concentrator on a
®
Windows NT
Table 2-1 outlines the different configurations the Model 5399 supports.

Table 2-1. Model 5399 Configuration Options

Device on which the
Operational Software and
Image is installed
UNIX Load Host
Another Model 5399
configured as a load server
Self-boot (from the image
contained in Flash memory)
®
Windows NT host
network.
Model 5399 Must
Be Connected to
the Network
Yes
Yes
No
Yes
®
host
®
allows
Input Device used to
Enter Basic
Configuration
Parameter Values
Service Port Terminal
Service Port Terminal
Service Port Terminal
Service Port Terminal