Table of Contents
Advertisement
Before you Begin
Remote Access Concentrator
T
his chapter describes how to install your Model 5399 Remote Access
Concentrator Module hardware and software, and connect it to a System
5000 Hub. This chapter provides the following information:
•
Before You Begin
•
Installing the Model 5399
•
Testing the Installation
•
Connecting a WAN Interface
•
Connecting a Service Port Terminal
•
Initial Setup and Using the ROM Monitor
•
Auto-initializing the ROMs
•
Installing the Software and Loading the Operational Image
•
Self-booting the Model 5399
•
Invoking the Console Monitor
To successfully install the Model 5399, you need:
•
A 3/16-inch flat-tip screwdriver
•
An antistatic mat and wrist strap (attached to an antistatic
leash)
•
A service port terminal and cable
•
A valid IP address
Nortel Networks 5399 Access Switch Hardware Installation Guide
Installing the Model 5399
Chapter 2
Module
2-1
Advertisement
Table of Contents
Troubleshooting
