Nextel iR1200 Administrator's Manual page 55

2 The Modems Properties window opens. Under the
General tab click Add.
3 The Install New Modem window opens. Select Other then
Next.
4 The Install New Modem/Hardware Installation window
opens. Check the Don' t run the Hardware Installation
Wizard box. Click the Next button.
NOTE: If this option is not present, proceed to the next
instruction.
5 The Install New Modem/Modem Detection window
opens. Check the Don' t detect my modem; I will select it
from a list box. Click Next.
6 The Install New Modem/Modem Selection window
opens. Under Manufacturer, select (Standard Modem
Types). Under Models, click Standard 19200 bps
Modem. Click Next.
7 The Port Selection window opens. Highlight the COM port
that you will be using to connect to the phone. Click Next.
8 The Modem Installation Finish window opens. Click
Finish.
9 The Modems Properties window reappears with the newly
added Standard 19200 bps modem displayed in the dialog
box. Click Close.
10 The following message appears: Dial-Up Networking
needs to be configured because the list has changed. Do
you wish to reconfigure? Click Yes.
11 The Remote Access Setup window opens. Click Add.
NOTE: In Windows NT, only one modem can be installed per
COM port. If you are attempting to install the Standard 19200
bps modem on a COM port to which another modem is
directed, you must choose an alternate COM port or remove
the other modem before proceeding. Otherwise a conflict will
RFM-4002-5015 Rev 3
Manual Modem Configuration
45