Eiki LC-WB200 Owner's Manual page 51

Power management
For reducing power consumption as well
as maintaining the lamp life, the Power
management function turns off the projection
lamp when the projector is not operated for a
certain period.
Select one of the following options:
Ready ........... When the lamp has been fully
cooled down, the POWER
indicator changes to green
blinking. In this condition,
the projection lamp will be
turned on if the input signal
is reconnected or any button
on the top control or remote
control is pressed.
Shut down ... When the lamp has been fully
cooled down, the power will
be turned off.
Off ................. Power management function
is off.
Timer ............ If the input signal is
interrupted and no button
is pressed for more than 30
seconds, the timer display
with No signal appears. It
starts the countdown until the
lamp is turned off. Use the
Point ▲▼ buttons to set the
Timer (1~30 min).
Note:
Factory default is Ready: 5 min.
Direct on
When this function is set to On, the projector will
be automatically turned on just by connecting
the AC power cord to a wall outlet.
Note:
Be sure to turn off the projector properly (see
"Turning Off the Projector" on page 20). If the
projector is turned off in the incorrect sequence, the
Direct on function will not work properly.
Power management
Time left before Lamp is off.
Setting
51