Led Status Indicators For 3500Yl And 6200Yl Series - HP 5400zl Series Technical Overview

The LED status indicators for the HP ProCurve Switch 5400zl series switch modules are described in
the following table.
LED State
Link On (green)
Off
Blinking (orange)
Mode Depending on the mode selected, displays:
• Network activity information
• Whether the port is configured for Full Duplex operation
• Maximum speed operation
• Whether PoE power is being supplied or not
Table 11. LED status indicators for HP ProCurve Switch 5400zl series—switch modules

LED status indicators for 3500yl and 6200yl series

The front panel of the HP ProCurve Switch 3500yl and 6200yl series has various LED status indicators
that are described in the following table.
LED State
Power On (green)
Off
Fault On (orange)
Off
Blinking (orange)
Test On (green)
Off
Blinking (orange)
Indication
Indicates the port is enabled and receiving a link beat signal
(for the twisted-pair ports), or a strong enough light level (for
the fiber-optic ports) from the connected device
Indicates no active network cable is connected to the port, the
port is not receiving link beat or sufficient light, or the port has
been disabled
If the port LED is blinking simultaneously with the Fault LED,
the corresponding port has failed its self-test.
Indication
The switch is receiving power.
The switch is NOT receiving power.
On briefly after the switch is powered on or reset, at the
beginning of switch self-test. If this LED is on for a
prolonged time, the switch has encountered a fatal hardware
failure, or has failed its self-test.
The normal state; indicates there are no fault conditions on
the switch.
A fault has occurred on the switch, one of the switch ports,
module in the rear of the switch, or the fan. The status LED
for that component will blink simultaneously.
The switch self-test and initialization are in progress after the
switch has been power cycled or reset. The switch is not
operational until this LED goes off. The Self Test LED also
comes on briefly when you "hot swap" a mini-GBIC into the
switch; the mini-GBIC is self-tested when it is hot swapped.
The normal operational state; the switch is not undergoing
self test.
A component of the switch has failed its self-test. The status
LED for that component will blink simultaneously.
61