Table of Contents
Advertisement
1/10GBASE-T autosensing Ethernet port
An HPE 5944 48XGT 6QS28 switch provides forty-eight 1/10GBASE-T autosensing Ethernet ports.
Table8-12 1/10GBASE-T autosensing Ethernet port specifications
Item
Connector type
Port transmission rate, duplex
mode, and auto-MDIX
Transmission medium and max
transmission distance
Compatible standards
To avoid interference between cables, layer cables as follows:
•
Use category-6A or above cables and connectors.
•
Do not bundle cables in their first 20 m (65.62 ft).
•
Separate power cords and twisted pair cables at and around the distribution frame.
•
For ports adjacent to one another on the device, the peer ports on the distribution frame are
preferably not adjacent, for example:
If the device connects to one distribution frame, connect port 1 on the device to port 1 on the
distribution frame, port 2 on the device to port 3 on the distribution frame, and port 3 on the
device to port 5 on the distribution frame.
If the device connects to two distribution frames, connect port 1 on the device to port 1 on
distribution frame 1, port 2 on the device to port 1 on distribution frame 2, and port 3 on the
device to port 2 on distribution frame 1.
LEDs
System status LED
The system status LED shows the operating status of the switch.
Table8-13 System status LED description
LED mark
SYS
Specification
RJ-45
1/10 Gbps, full duplex, MDI/MDIX autosensing
•
•
•
•
•
Status
Description
Steady green
The switch is operating correctly.
Flashing green
The switch is performing power-on self test (POST).
Steady red
The system has failed POST, or a fault has occurred.
Flashing red
Some ports have failed POST.
Helps you to locate the device.
Flashing blue (3 Hz)
To locate the device, execute the
the device. Then the SYS LED will be in this state.
Off
The switch is powered off or has failed to start up.
55 m (180.45 ft) over category-6 unshielded twisted pair cable
100 m (328.08 ft) over category-6 shielded twisted pair cable
100 m (328.08 ft) over category-6A or above twisted pair cable
IEEE 802.3ab
IEEE 802.3an
8-44
locator blink
command on
Advertisement
Table of Contents
