Ignition Cycles; Running In Minimum Or Maximum; Running In The Comfort Level Mode; Clear Space - Pelpro PP60 Owner's Manual

J. Ignition Cycles
1. At the beginning of each ignition cycle, it is normal to see
some smoke in the firebox. The smoke will stop once
the fire starts.
2. The convection blower will automatically turn on after
your appliance has been burning for approximately 10
minutes.
This blower transfers heat from your appliance into the
room, and will continue to run even after the unit has
shutdown. It will turn off after the exhaust temperature
has cooled.
3. Occasionally the appliance may run out of fuel and shut
itself down. When this happens the empty hopper alarm
will be triggered.
K. Running in Minimum or Maximum
When the dial control is set to run on the LO or HI setting,
the appliance will continue to run without regard to the
actual temperature in the room. The appliance will shut off
only if the dial control is set to a different setting or there is
an error such as an empty hopper.
When running on LO or HI it is important to follow the daily
cleaning activities especially cleaning the firepot. Failure
to do so will reduce the performance of the appliance.
L. Running in the Comfort Level Mode
When the dial control is set to run in the automatic mode
the unit will adjust the actual burn rate based on the
difference between the room temperature as sensed by
the probe located in the rear of the unit and the desired
comfort level as set on the dial control.
The comfort level range is from 65 degrees Fahrenheit to
82 degrees Fahrenheit.
Once the desired comfort level is achieved the appliance
will automatically shut down and turn off. When the Priming Fuel Minimum / Maximum **
temperature in the room drops 3 degrees below the
carburant d'amorçage minimale / maximale
desired comfort level, the appliance will automatically
cebado de combustible
restart.
2
1
LO
www.pelprostoves.com
Daily / Quotidien / Todos los días
mínimo / máximo
5
4
6
3
7
8
9
10
OFF
HI
Weekly / Hebdomandair / Semanalmente
7083-171B • July 23, 2013
M. Clear Space
WARNING! RISK OF FIRE! Do NOT place combustible
objects in front or to the sides of the appliance. High tem-
peratures may ignite clothing, furniture or draperies.
Mantel: Avoid placing candles and other heat-sensitive
objects on mantel or hearth. Heat may damage these
objects.
NOTICE: Clearances may only be reduced by means ap-
proved by the regulatory authority having jurisdiction.
WARNING! RISK OF FIRE! Keep combustible materials,
gasoline and other flammable vapors and liquids clear of
appliance.
• Do NOT store flammable materials in the appliance's
vicinity.
• Do NOT use gasoline, lantern fuel, kerosene, charcoal
lighter fluid or similar liquids to start or "freshen up" a fire
in this heater.
Keep all such liquids well away from the heater while it is in
use as combustible materials may ignite.
N. Trim Adjustment
NOTE: The right side panel must be removed to
make trim adjustments with the dial control
To see a visual, go to page18 & reference side panel replacement part
The small dial located below the main dial control is used
to adjust the amount of combustion air for the fire. You
may need to adjust the combustion air to the fire for:
Elevation
Venting/Installation Configurations
Fuel Quality
If your fire is too large, lazy, or producing black soot, you
need MORE air. To increase the amount of combus-
Maintenance / Entretien / Mantenimiento
tion air, rotate counterclockwise one level at a time and
allow 15 minutes for stabilization prior to making another
adjustment. If your fire is too small and sometimes goes
out when there are pellets in the hopper, you may have
too much air (too lean). To decrease the amount of
combustion air, rotate clockwise one level at a time and
allow 15 minutes for stabilization prior to making another
adjustment.
Empty Firepot / Creuset Vide / Brasero De Fuego Vacía
11.75
Clean Firepot / Clean Creuset / Limpieza Brasero De Fue
5 Bags / 5 Sacs / 5 Bo
1 Bag / 1 Sac / 1 B
11