General Operating Information; User Dial Control; Filling The Hopper; Priming The Feed Tube - Pelpro PP60 Owner's Manual

3

General Operating Information

A. User Dial Control
The appliance has one dial control located on the side of
the unit used for daily operation. There are four primary
settings on this dial.
1) OFF: When the dial indicator is in the off position
the unit will go into a shut down and remain off until the
dial is turned to one of the other three settings. The LED
will flash green once per second when in the off position.
2) LO : When the dial indicator is directed to the LO
setting (small flame on the label) the unit will burn on
low until the hopper runs out of pellets or the dial con-
trol is turned to a different setting. When in this setting
the LED will be amber in color and continuously on.
When burning in this mode, the unit should be turned
off at least once daily for cleaning. If lower quality fuels
are used, additional daily shut downs may be required
for cleaning.
3) HI : Similar to the LO mode, the unit will run continu-
ously at the high burn rate until the unit has run out of
fuel or the dial is turned to a different setting. To oper-
ate in this mode, turn the dial clockwise until it stops.
The dial indicator will point to the large flame. When in
this setting the LED will be amber in color and continu-
ously on. Follow the daily cleaning recommendations
when operating in this mode. If lower quality fuels are
used, additional daily shut downs may be required for
cleaning.
4) COMFORT LEVEL : To burn in the Comfort Level
mode, turn the dial control clockwise to the desired
comfort level. When operating in the automatic mode,
the unit changes the burn setting based on the differ-
ence between the room temperature and the desired
set point. In other words, the unit will burn on High if the
difference between the desired and room temperature is
greater than 8 degrees Fahrenheit. As the room heats
up and the gap closes, the unit will automatically reduce
the burn rate. When the room temperature is close to
the set point the light will stop flashing stay solid green.
at this time the stove will be burning on the lowest burn
rate. When the desired temperature is achieved the unit
NOTE: will shut down. As the room cools, the unit will restart
automatically. When burning in this mode the LED will
1. MATERIAL: NON-ANODIZED ALUMINUM 0.020 THICK
be blinking green. The number of green flashes corre-
2. BACKGROUND: BLACK
sponds to the current setting.
3. COPY: SILVER
4. ADHESIVE: 3M #468 PERMANENT ACRYLIC
5. TEMPERATURE RATING: -50°F TO 350°F
www.pelprostoves.com
A RELEASED
Operation / Opération / Operación
Automatic Mode *
mode Automatique
Modo Automático
Starting
1. Turn dial control to OFF position.
2. Fill hopper with pellets.
3. Turn dial control to desired setting.
Départ
1. Tourner le cadran de commande en
position OFF.
2. Remplir la trémie avec des granulés.
3. Tourner le cadran de commande au réglage
désiré.
A partir
1. Gire el dial de control en la posición OFF.
6.75
2. Llene la tolva con perdigones.
3. Gire el dial de control hasta la posición deseada.
Stopping
1. Turn dial control to OFF position.
2. Allow unit to cool before performing any maintenance.
NOTE:
Arrêt
1. MATERIAL: MYLAR
2. ADHESIVE: 3M #468 PERMANENT ACRYLIC
1. Tourner le cadran de commande en position OFF.
3. TEMPERATURE RATING: INK @ 325°F
2. Laissez refroidir avant d'e ectuer toute opération de maintenance.
Parada
1. Gire el dial de control en la posición OFF.
2. Deje enfriar la unidad antes de realizar cualquier trabajo de mantenimiento.
02 RELEASE FOR TOOLING
REV REVISIONS
* The appliance will automatically maintain the desired comfort level and shut down when level
has been achieved.
L'appareil passera automatiquement maintenir le niveau de confort désiré et arrêter lorsque le
niveau a été atteint.
El aparato mantendrá automáticamente el nivel de confort deseado y se cerrará cuando el nivel
se ha logrado.
** The appliance will run continuously until switched to OFF or AUTOMATIC mode.
L'appareil fonctionne de façon continue jusqu'à ce que passe en mode OFF ou AUTOMATIQUE.
El aparato funciona continuamente hasta que cambia al modo OFF o AUTOMÁTICO.
7083-171B • July 23, 2013
Priming Fuel Minimum / Maximum **
carburant d'amorçage minimale / maximale
cebado de combustible
2
2
1
1
3.75
LO
LO
About 65 •F
B. Filling the Hopper
Slowly open the hopper lid by lifting the handle. The
medium and large units have a locking latch that will
engage when the hopper lid is fully opened. The hopper lid
for the cabinet will open past ninety degrees and stay open
automatically. Fill the hopper with fuel. FOR USE WITH
ONLY WOOD PELLET FUEL. Slowly close the hopper lid.
UNLESS OTHERWISE SPECIFIED DIMS ARE INCHES[MM] & : TOLERANCES ARE: (2) PLACE DEC : ± 0.03
See figure below for releasing the latch. NOTE: The unit
will not feed with the hopper lid open. If left open, the fire
will go out.
72901 04/29/13 MCW
CONFIDENTIAL PROPERTY OF HEARTH & HOME TECHNOLOGIES INC.
DATE
ECO # BY
C. Priming the Feed Tube
Only if the hopper is being filled for the first time or the
unit had previously run out of pellets, the feed tube may
need to be primed. To do this, turn the dial control from
the OFF position to the HI position two times. This will run
the feed motor continuously for two minutes without turning
the igniter on. When the auger is running continuously,
the LED will be a continuous green color. The system will
run the auger for 2 minutes. When pellets start to drop into
the firepot, the feed tube is primed; turn the dial control
to the desired position and the stove will begin its ignition
sequence (The green LED will flash rapidly).
Daily / Quotidien / Tod
2.81
mínimo / máximo
5
5
4
4
6
6
3
3
7 7
8
8
9
9
10
10
OFF
HI
OFF
HI
Weekly / Hebdomanda
Monthly / Mensuel / M
OUTSIDE MATERIAL. NORMAL DIM & INSIDE MATERIAL.
Push Bottom of Latch
Inward to Release
72906 06/20/13
Maint
4X R0.13
Empty Firepot / Creuset Vi
About 82 •F
Clean Holes / Nettoyer Les
OUTSIDE APEX INSIDE AP
PART NAME:
LAB
DRAWN BY: SCALE:
MCW 1:1
THIS PRINT IS CHECKED AND CONTROLLED BY THE E
DEPARTMENTS OF HEARTH & HOME TECHNOLOG
3
1
Remove / Sup
7
MCW