Configure Ip Address - Planet WGSW-28040 User Manual
28-port 10/100/1000mbps with 4 shared sfp managed gigabit switch
Hide thumbs
Also See for WGSW-28040:
- User manual (324 pages) ,
- Command manual (351 pages) ,
- Quick installation manual (16 pages)
Table of Contents
Advertisement
1.
For security reason, please change and memorize the new password after this first setup.
2.
Only accept command in lowercase letter under console interface.
Configure IP address
The SGSW Managed Switch is shipped with default IP address as following.
IP Address: 192.168.0.100
Subnet Mask: 255.255.255.0
To check the current IP address or modify a new IP address for the Switch, please use the procedures as follow:
Show the current IP address
1.
On "WGSW-28040#" prompt, enter "config".
2.
On "WGSW-28040(config)#" prompt, enter "show ip".
3.
The screen displays the current IP address, Subnet Mask and Gateway. As show in
Configure IP address
4.
On "WGSW-28040(config)#" prompt, enter the following command and press <Enter>. As show in
WGSW-28040(config)# ip address 192.168.1.100 255.255.255.0
WGSW-28040(config)# ip default-gateway 192.168.1.254
The previous command would apply the follow settings for the Switch.
Figure 5-2 Show IP information screen
181
User's Manual of WGSW-28040 / 28040P
Figure
5-2.
Figure
5-3.
Advertisement
Table of Contents
