• Dst-ip
• Ip-portocol
• Tos
• L4-src-port
• L4-dst-port
• Tcp-flag
• Action
4.10.2 ACL Template Setting
This page allows you to configure the ACL Template Setting. The ACL Template Setting screen in
Destination IP address. A subnet mask containing four integers from 0 to 255,
each separated by a period. The mask uses 1 bits to indicate "match" and 0 bits
to indicate "ignore." The mask is bitwise ANDed with the specified source IP
address, and compared with the address for each IP packet entering the port(s)
to which this ACL has been assigned.
Specifies the protocol type to match as TCP or UDP.
Specifies the ToS value.
Specifies the L4 source protocol port.
Specifies the L4 destination protocol port.
Specifies the TCP flag value.
An ACE can contain any combination of permit or deny rules.
(Default: Permit rules)
Figure 4-10-4 ACL Template Setting page screenshot
162
User's Manual of WGSW-28040 / 28040P
Figure 4-10-4
appears.