Unpacking And Placement; Unpacking Your Amplifier; Placement; Ventilation - Classe Audio CA-D200 Owner's Manual

unpacking your amplifier Carefully unpack your power amplifier according to the supplied instructions,
Important!
placement Many installations will utilize an equipment rack, although a shelf, a cabinet or
ventilation Your Classé power amplifier generates a certain amount of heat in the course of
custom installations Drawings are included in this manual to facilitate special installations and
serial number The serial number for your power amplifier is found on the rear of the unit.
operating voltage The operating voltage of your CA-D200 is 100-240 V, 50/60 Hz.
6

Unpacking and Placement

and remove all accessories from the carton. Please take care when lifting the
amplifier, as it is heavier than it may appear.
Keep all packing materials for future transport of your
Classé amplifier. Shipping your new component in
anything other than its purpose-designed packing material
may result in damage that is not covered by the warranty.
the floor near the speaker(s) are acceptable alternatives. In any case, take care to
position it well away from source components and preamp/processors, which
may be sensitive to the amplifier's electromagnetic fields.
Note that adequate clearance for the AC cord and connecting cables
must be left behind the amplifier. We suggest leaving six inches (15 cm)
of free space behind your power amplifier to allow all cables sufficient
room to bend without crimping or undue strain.
normal operation. Avoid placement on soft surfaces that would restrict airflow
around the unit (such as plush carpeting).
custom cabinetry (see the section Dimensions). Contact your Classé dealer for
more information.
Please note and record this number on the page entitled Important Safety
Instructions for your future reference.
Warning: There are no user-serviceable parts within the unit. Please
refer any problems to an authorized Classé service center.
The amplifier can easily be powered by a normal 15 or 20-ampere AC mains
line. If other devices are also powered from the same AC line, their additional
power consumption should be taken into account.