Classe Audio CA-D200 Owner's Manual page 13

RJ-45 - DB9 female adaptor
If your RS-232 control system uses a cable with a male DB9 connector,
you will need to buy or build an adaptor to convert the RJ-45 female to a
DB9 female. Standard RJ45-to-DB9 female connectors come with RJ-45
pins and colors as below. Wire the DB9 adaptor according to this diagram
and table.
Remarks: The Cat 5 cable and connector that is used for the adaptor and
plugs into the rear panel RJ-45 port must use pin-to-pin wiring.
8 USB Port
The USB connector is used to host a USB stick for updating amplifier
firmware, should that become necessary.
9 AC Mains Input
An IEC standard power cord (supplied) is used with the CA-D200. Plug
the cord into the IEC receptacle on the rear panel, and the other end into
a suitable wall outlet.
10 AC Mains Fuse
Your Classé power amplifier has an AC mains fuse, accessible on the
rear panel. If you suspect that your AC fuse has blown, disconnect your
amplifier from the AC mains, as well as from its input connections and
speaker connections, and refer to the appropriate item of the section
enitled Troubleshooting.
Do not open your amplifier. There are no user-serviceable parts within
this product.
Danger! Potentially dangerous voltages and current capabilities
exist within your power amplifier, even when disconnected
from AC mains. Do not attempt to open any portion of the
amplifier's cabinet. There are no user-serviceable parts
inside your power amplifier. All service of this product
must be referred to a qualified Classé dealer or distributor.
RJ-45
Pin-1 = Blue
Pin-2 = Orange
Pin-3 = Black
Pin-4 = Red
Pin-5 = Green
Pin-6 = Yellow
Pin-7 = Brown
Pin-8 = White
DB9
Pin-1 = Brown
Pin-2 = Green
Pin-3 = Yellow
Pin-4 = Orange
Pin-5 = Red
Pin-6 = Blue
Pin-7 = NC
Pin-8 = Black
Pin-9 = White
13