Configuring Snmp; Configuring Remote Alarm Host - HIKVISION Network Video Recorder User Manual

User Manual of Network Video Recorder
in a more customized network, NTP software can be used to establish a NTP server used for time
synchronization.

9.2.4 Configuring SNMP

Purpose:
You can use SNMP protocol to get device status and parameters related information.
Steps:
1. Enter the Network Settings interface.
Menu >Configuration> Network
2. Select the SNMP tab to enter the SNMP Settings interface, as shown in Figure 9. 13.
3. Check the SNMP checkbox to enable this feature.
4. Configure the following SNMP settings:
•
Trap Address: IP Address of SNMP host.
•
Trap Port: Port of SNMP host.
5. Click the Apply button to save and exit the interface.
Before setting the SNMP, please download the SNMP software and manage to receive the device
information via SNMP port. By setting the Trap Address, the NVR is allowed to send the alarm event and
exception message to the surveillance center.

9.2.5 Configuring Remote Alarm Host

Purpose:
With a remote alarm host configured, the NVR will send the alarm event or exception message to the host when an
alarm is triggered. The remote alarm host must have the Network Video Surveillance software installed.
Steps:
1. Enter the Network Settings interface.
Menu >Configuration> Network
2. Select the More Settings tab to enter the More Settings interface, as shown in Figure 9. 14.
Figure 9. 13 SNMP Settings Interface
138