Table of Contents
Advertisement
7. Connect the included USB cable from the hard drive dock to an available USB port
on the computer system. The computer can be on or off.
NOTE: The USB 3.0 cable can be connected to a USB 2.0 port, however will only be able
to operate at USB 2.0 speeds.
8. Press the power button on the front of the dock. Button 1 is for the SATA drive, and
button 2 is for the IDE drive.
9. The SATA drive bay has an ejection button next to it, that can be pressed to help
pull the drive free from the bay. NOTE: Drives should be powered off before being
removed from the dock.
Driver Installation
No driver installation is required for the supported operating systems, as this hard
drive dock is natively supported, so the drivers are already installed.
Instruction Manual
4
Advertisement
Table of Contents
Need help?
Do you have a question about the UNIDOCK3U and is the answer not in the manual?
Questions and answers