NetComm NWL-12-01 User Manual page 98

get ledmode
set ledmode
get ssh.proto
set ssh.proto
get ssh.passauth
set ssh.passauth
get.ssh.keyauth
set.ssh.keyauth
List of basic RDB variables
The following table lists valid variables where "x" is a profile number (1-6). If no profile is specified, variables are read from or written
to for the current active profile. If a profile is specified, variables are read from or written to for the specified profile number ('x').
# RDB VARIABLE NAME
link.profile.1.enable
link.profile.1.apn
link.profile.1.user
0
link.profile.1.pass
link.profile.1.auth_type
link.profile.1.iplocal
link.profile.1.status
2 link.profile.1.user
3 link.profile.1.pass
4 link.profile.1.auth_type
5 link.profile.1.iplocal
6 wwan.0.radio.information.signal_strength
7 wwan.0.imei
8 statistics.usage_current
9 statistics.usage_current
10 /proc/uptime
wwan.0.system_network_status.current_ba
11
nd
Network scan and manual network selection by SMS
Performing a network scan
The get plmnscan SMS command enables you to perform a scan of the cellular networks available at the time of the scan.
It returns the following semi-colon separated information for each network in range:
MCC
MNC
Network Type (3G, 2G)
Provider's Name
Operator Status (available, forbidden, current)
NetComm Wireless 3G Light Industrial M2M Router
98
get ledmode
set ledmode=10
get ssh.proto
set ssh.proto=1,2
get ssh.passauth
set ssh.passauth=1
get.ssh.keyauth
set.ssh.keyauth=1
Table 25 - List of get/set commands
SMS VARIABLE
NAME
profile
username
password
authtype
wanip
rssi
imei
usage
wanuptime
deviceuptime
band
Table 26 - List of basic SMS diagnostics RDB variables
Returns the status of the LED operation mode.
Sets the LED operation mode to be always on or to turn off after the specified number of
minutes.
Returns the SSH protocol in use.
Sets the SSH Protocol to protocol 1, 2 or both (1,2).
Returns the status of the SSH Enable password authentication option.
Sets the SSH Enable password authentication option on or off.
Returns the status of the SSH Enable key authentication option.
Sets the SSH Enable key authentication option on or off.
READ/
DESCRIPTION
WRITE
RW Profile
RW 3G username
RW 3G password
3G Authentication
RW
type
R WAN IP address
R 3G signal strength
R IMEI number
3G data usage of
R
current session
Up time of current 3G
R
session
R Device up time
R Current band
EXAMPLE VALUE
Read:
(profile no,apn,user,pass,auth,iplocal,status)
1,apn,username,password,
chap,202.44.185.111,up
Write:
(apn, user, pass,auth)
apn,username,password
Guest, could also return "null"
Guest, could also return "null"
"pap" or"chap"
202.44.185.111
-65 dBm
357347050000177
"Rx 500 bytes, Tx 1024 bytes, Total 1524
bytes" or "Rx 0 byte, Tx 0 byte, Total 0 byte"
when wwan down
1 days 02:30:12 or 0 days 00:00:00 when
wwan down
1 days 02:30:12
WCDMA850
www.netcommwireless.com