Replacing The Power Switch/ Led Assembly - Lenovo 7387 Hardware Maintenance Manual

Replacing the power switch/ LED assembly

1. Disconnect the power switch/LED assembly cable from the system board. See
2. Remove the front bezel. See "Removing and replacing the front bezel" on page
3. Remove the power switch/LED assembly by disconnecting it from the inside of
4. Install the new power switch/LED assembly into the bezel.
5. Route the cable for the new power switch/LED assembly through the hole in
6. Reinstall the bezel. See "Removing and replacing the front bezel" on page 89.
7. Reconnect the power switch/LED cable to the system board.
8. Go to "Completing the FRU replacement" on page 112.
110
Lenovo 3000 J Series
"Identifying parts on the system board" on page 87.
89.
the bezel.
the chassis and to the system board.