Replacing An Optical Drive - Lenovo 7387 Hardware Maintenance Manual

Replacing an optical drive

1. Remove the left-side and right-side covers. See "Removing the covers" on page
2. Disconnect the power cable and signal cable from the optical drive.
3. Remove the two screws that secure the drive on each side.
4. Slide the drive being replaced out the front of the computer.
5. If the drive you are replacing has jumpers on the rear, make sure the jumpers
6. Slide the new drive into the bay until the screws holes on each side are aligned
7. Reconnect the power cable and signal cable to the new optical drive.
8. Go to "Completing the FRU replacement" on page 112.
108
Lenovo 3000 J Series
84.
on the new drive are in the same exact position as the drive being replaced.
and install two screws in each side of the drive.