Replacing the power switch/ LED assembly
1. Disconnect the power switch/LED assembly cable from the system board. See
2. Remove the front bezel. See "Removing and replacing the front bezel" on page
3. Remove the power switch/LED assembly by disconnecting it from the inside of
4. Install the new power switch/LED assembly into the bezel.
5. Route the cable for the new power switch/LED assembly through the hole in
6. Reinstall the bezel. See "Removing and replacing the front bezel" on page 87.
7. Reconnect the power switch/LED cable to the system board.
8. Go to "Completing the FRU replacement" on page 105.
"Identifying parts on the system board" on page 85.
87.
the bezel.
the chassis and to the system board.
Chapter 8. Replacing FRUs (Type 9626)
103