Lenovo 7387 Hardware Maintenance Manual page 125

4. Slide the drive bay assembly forward until it stops. Disconnect the power
supply and signal cables from the drives. Pivot the rear of the drive bay
assembly upward to remove it completely from the computer.
Note: To allow easier access to the cables, lift the fan plenum off the heat sink.
See "Locations" on page 115.
5. Reverse this procedure to replace the drive bay assembly and bezel.
Chapter 9. Replacing FRUs (Types 7390, 7391, 7392, 7396, 7397, and 7398)
119