Advertisement
32
EN
Fitting fabrics (1)
Removing the Carry Cot (6)
Locate the longest handle strap and
Unlock the locking mechanism by flipping
thread it through the hole at the rear
the lever (K) downwards.
part of the Carry Cot.
Unhook the locking mechanism from the
Put the locking pin into the loop at the
Carry Cot by pressing the back of the
end of the handle Strap.
locking mechanism.
Attach the handle strap to the Carry
Slide the locking mechanism up to the
Cot by pressing the pin into the slot on
handle and secure it by flipping the lever (K)
the bottom of the Carry Cot.
up and in towards the central bar. Press up
Locate the shortest handle strap and
the handles (L) on each side of the Carry
thread it through the hole at the front
Cot, hold them up and lift up the Carry Cot.
of the Carry Cot. Put the locking pin
into the loop at the end of the handle
Use of the Carry Cot (7)
strap.
The Carry Cot can be carried using the two
Attach the handle strap into the Carry
handles straps located on either side. When
Cot by pressing the pin into the slot on
the handle straps are not in use, they can be
the bottom of the Carry Cot.
stored away in the pockets inside the Carry
Repeat the procedure for the handle
Cot. The Carry Cot can be placed on the
strap on the other side of the Carry Cot.
floor, it can also be rocked. The Carry Cot is
When both of the handle straps are
equipped with D-rings for a harness *).
assembled, you can secure the lining.
* Note: harness is not required and not
Start with the corner at the rear part of
available in some countries such as the
the Carry Cot.
USA/Canada.
Stretch the lining and place it all the
way around the rim of the Carry Cot.
Accessory pockets (8)
Turn the Carry Cot upside down and
The Carry Cot has two practical storage
attach the lining by placing the holes
pockets, perfect for a bottle, dummy or
around the hooks/teeth under the rim.
even your phone.
There are six hooks, three on each side.
Finally place the mattress into the Carry
Cover (9)
Cot.
Place the cover on top of the Carry Cot.
Attach the cover with the push buttons on
Assembling hood on carry cot (2)
each side. Attach elastic on cover to the
Position and push the hood plastic fas-
inside of hood.
teners in on each side of the bag.
Attach the hood to the Carry Cot lining
Hood visor (10)
with the zipper.
Attach and detach the visor from the hood
Attach the push buttons on each side.
with the zip. Fold in and out.
Dismounting hood from seat (3)
Rain cover (11)
Unbutton on each side of the hood.
Place the rain cover over the Carry Cot and
Unzip to release the hood. Release plas-
hood. Firmly fasten the Velcro around the
tic fasteners from seat by pressing the
central bar.
two taps on the inside of the seat. Use
both tombs and press.
Mosquito net (12)
Pull the mosquito net over the handle.
Assembling the locking mechanism
Pull the mosquito net over the main rib of
for the Carry Cot (4)
the hood. Secure it around the main rib.
Start by adjusting the handle to the hig-
Fasten the mosquito net with the push but-
hest position.
tons. One on each side.
Place the V shaped part around the cen-
Pull the net over the carry cot so that it
tral bar as shown.
covers the entire bag.
Place the lever into the holes.
Pull the zippers, one on each side of the
Note! The large pin goes into the large
central bar.
hole, and the small pin into the small
hole. Fasten the locking mechanism to
Dismount the fabrics
the central bar, by pressing the lever
Unhook the lining at front.
(K) up and in towards the central bar.
Unhook the lining from the hooks/teeth
under the rim. Three on each side.
Assembling the Carry Cot (5)
Push the Carry Cot down onto the arms
Changing bag
until you hear a click on each side.
Attach the hooks to the attachment rings.
Check to see that the Carry Cot is pro-
perly mounted on the arms. The indica-
tors on each side should be green. The
Carry Cot must then be locked in positi-
on around the central bar. Unlock the
locking mechanism by flipping the lever
(K) downwards.
Slide the locking mechanism down and
hook the front of it onto the Carry Cot.
Lock it by flipping the lever (K) up and
in towards the central bar.
Stokke
®
Xplory
®
Carry Cot
Maintenance – Washing instructions
HARD PARTS: The stroller should be
cleaned using a mild mixture of water and
soap. Make sure that any sand/mud/grit
is removed prior cleaning. No parts on the
stroller shall be lubricated. If any function of
the stroller is not working, please contact
your nearest STOKKE retailer.
TEXTILES: Must be washed seperately, se
care label on items for instructions.
Stokke® Warranty card /
Product registration card
See description of where to find the
products serial number/date clock on your
product. Use this information when filling
out the Stokke warranty card / Product
registration card. We
recommend that you fill in this
information at www.stokke.com.
Stokke
®
Xplory
®
Carry Cot
33
AE
Hide quick links:
Advertisement
