Notice For Canada - ProCurve 420 Installation And Getting Started Manual

Safety and EMC Regulatory Statements
EMC Regulatory Statements
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate
this equipment.
The availability of some specific channels and/or operational frequency bands
are country dependent and are firmware programmed at the factory to match
the intended destination. The firmware setting is not accessible by the end
user.

Notice for Canada

This device complies with RSS-210 of the Industry Canada Rules. Operation
is subject to the following two conditions: 1) this device may not cause
interference, and 2) this device must accept any interference, including inter-
ference that may cause undesired operation of the device.
This device has been designed to operate with an antenna having a maximum
gain of 10.7 dBi.
Antennas having a higher gain is strictly prohibited per regulations of Industry
Canada. The required antenna impedance is 50 ohms.
To reduce potential radio interference to other users, the antenna type and its
gain should be so chosen that the EIRP is not more than required for successful
communication.
C-10
Warning: FCC Radiation Exposure Statement
!
This equipment complies with FCC radiation exposure limits set
forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20 cm (8 inches)
between the radiator and your body.
This transmitter must not be co-located or operating in conjunc-
tion with any other antenna or transmitter.
Warning: IC Radiation Exposure Statement
!
This equipment complies with IC radiation exposure limits set
forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20 cm (8 inches)
between the radiator and your body.