Setting The Antenna Mode Using The Cli; Setting The Antenna Mode Using The Web Interface - ProCurve 420 Installation And Getting Started Manual

Using an External Antenna with the Access Point 420
Installation Procedures

Setting the Antenna Mode Using the CLI

1.
2.
3.

Setting the Antenna Mode Using the Web Interface

1.
2.
3.
4.
5.
4-8
Type configure to enter global configuration mode.
HP420#configure
Enter configuration commands, one per line. End with
CTRL/Z
HP420(config)#
Type interface wireless g to enter interface configuration mode.
HP420(config)#interface wireless g
Enter Wireless configuration commands, one per line.
HP420(if-wireless g)#
Type antenna-mode diversity if using a diversity antenna.
HP420(config)#antenna-mode diversity
Type antenna-mode single if using a non-diversity antenna.
HP420(config)#antenna-mode single
Select the Configuration tab.
Click the [
Port/Radio Settings]
Scroll down to the External Antennas section at the bottom of the page.
From the Antenna Mode drop-down menu, select Diversity or Single for the
type of antenna attached to the access point.
Click the
[Apply Changes]
button.
button.