To Set The Access Point's Ip Address - ProCurve 420 Installation And Getting Started Manual

Type configure to enter global configuration mode.
3.
HP ProCurve Access Point 420#configure
Enter configuration commands, one per line.
HP ProCurve Access Point 420(config)#
Type management to enter management configuration.
4.
HP ProCurve Access Point 420(config)management
Enter management commands, one per line.
HP ProCurve Access Point 420(config-mgmt)#
Type username-admin username to create a user name for the Manager,
5.
where username can consist of 3 to 16 alphanumeric characters and is case
sensitive.
HP ProCurve Access Point 420(config-mgmt)#username-admin steve
HP ProCurve Access Point 420(config-mgmt)#
Type password-admin password to create a password for the Manager,
6.
where password can consist of up to 16 alphanumeric characters and is
case sensitive.
HP ProCurve Access Point 420(config-mgmt)#password-admin 1AB2F
HP ProCurve Access Point 420(config-mgmt)#

To Set the Access Point's IP Address

By default, the access point is configured to automatically receive IP
addressing from a Dynamic Host Configuration Protocol (DHCP) server.
However, if you are not using a DHCP server to configure IP addressing, use
the CLI to manually configure the IP values.
From the global configuration mode, type interface ethernet to access the
1.
Ethernet interface-configuration mode.
HP ProCurve Access Point 420(config)#interface ethernet
Enter Ethernet configuration commands, one per line.
HP ProCurve Access Point 420(if-ethernet)#
Getting Started With Access Point Configuration
3-3