Reset Button - ProCurve 420 Installation And Getting Started Manual

Reset Button

This button is used to reset the hardware or restore the factory defaults:
■
■
N o t e
The Reset button and console port can be disabled by the access point's
software. For more information, see the Management and Configuration
Guide, available on the ProCurve Web site at
http://www.hp.com/rnd/support/manuals/420.htm.
To Reset the Access Point While it is Powered On – This action clears
any temporary error conditions that may have occurred and executes the
access point self test.
To Restore Factory Default Configuration – When the Reset button
is pressed for more than five seconds, any configuration changes you may
have made through the access point console or the web browser interface
are removed, and the factory default configuration is restored to the
access point. For the specific method to restore the factory default
configuration, see "Restoring the Factory Default Configuration" in
chapter 5, "Troubleshooting" of this manual.
Introducing the ProCurve Wireless Access Point 420
Back of the Access Point
1-7